Initial Setup
In this guide, we'll show you the basic setup and installation for your GoSwift Recorder and the GoSwift Viewer Software.
Sections in this guide
Initial Wiring and Setup

-
If you connected your DVR to an HD-TV, you will see the following message after booting up:
-
Click OK to have your DVR’s output resolution optimized
-
If you click OK, and the overall image has improved, click OK again to save the settings. However, if the image has been degraded, click Cancel to revert back to the original quality.
You can manually adjust the NVR output by logging in and going to
Setup > System > General > Output ConfigurationBe sure to adjust the output to your HDTV’s resolution capabilities.
-
To Login, Click anywhere on the screen, then click the bottom left hand icon, then setup.
Default password is: admin789
Download and install the GoSwift Viewer Software onto your PC.
Software can be downloaded from the following links:
Make sure your camera is hooked into a network that has internet access. If you do not have internet access, please visit our guide for "Getting Setup Without Internet Access".
Setup the GoSwift Viewer Software
-
Open up the GoSwift Viewer Program and Enter in your Product ID.
-
Your product ID can be found on the recorder itself as well as the box, the ID is found near a QR Code.
-
Choose DVR/NVR as the type of device to login to and enter the product ID. The default port is 7050. The Default Username and Password are admin / admin789.
-
-
Click Login. Congrats you are done!